Thirteen instruments.
These model the Serpentis-class exo-suit and wingsuit programme — the material science and aerodynamic architecture shared across DragonSuit, GripSuit, AquaSuit and the JumpSuit platform.
Wind Tunnel Simulator
Real-time aerodynamic analysis for the Serpentis-class wing. Dial in airspeed, angle of attack, altitude, wing area and pilot mass. Toggle biomimetic surface features — denticle, tubercle LE, auxetic, washout, fairing — and watch lift, drag, glide ratio and range update instantly.
Open in new tab ↗Grip Matrix Simulator
Friction coefficient and shear adhesion modelling across every Serpentis-class surface configuration against every substrate the GripSuit encounters: glass, concrete, steel, painted metal, stone and wet conditions. Identifies which adhesion mode dominates on each surface.
Open in new tab ↗Thermal Envelope
Material performance across the full temperature swing of a Serpentis-class jump — from high-altitude cold soak through freefall aerodynamic heating to ground-impact thermal spike. Phase transition windows, SMP stiffness degradation curves and operational limit flags per layer.
Open in new tab ↗Membrane Deployment Timer
Simulates the full deployment sequence: accelerometer freefall detection, MRE membrane activation, contact area extension against altitude consumed. Defines the minimum safe exit altitude for any jump profile.
Open in new tab ↗Spinal Node Fatigue Predictor
Cycle life estimation for the (TiZrHf)₄₄Ni₂₅Cu₁₅Co₁₀Nb₆ high-entropy alloy vertebral nodes under repeated dynamic loading. Miner's Rule cumulative damage with a strain-glass microstructure fatigue model.
Open in new tab ↗Exo-Fascia Impact Simulator
Validates the three-layer exo-fascia composite through an egg-drop physics model. Adjust shell stiffness, mid-layer absorption and inner padding compliance, then watch kinetic energy distribute across each layer before reaching the core.
Open in new tab ↗Biomimicry Matrix
The full DragonWorx biological reference matrix — every creature, every mechanism, every platform application and TRL level across the complete portfolio. The master map of nature's engineering solutions to our design problems.
Open in new tab ↗SMP Formulation Designer
Interactive Tg and modulus tuning for thermoset shape-memory polymers. Dial in crosslink density, monomer ratio and chain extender to target independent Tg and rubbery modulus for DragonSuit rib fabrication, neural probe substrates and wearable electronics.
Open in new tab ↗Stiffness Gradient Designer
Models spatially-graded stiffness transitions across multi-layer polymer substrates — from rigid device interface to compliant tissue contact. Calculates delamination risk, peak interfacial strain and mechanical mismatch index.
Open in new tab ↗Diels-Alder CAN Designer
Models furan-maleimide Diels-Alder covalent adaptable networks for reprocessable thermosets, recyclable composites and shape-morphing structures. Tune crosslink density, monomer MW and regiochemistry to predict retro-DA temperature and gel fraction.
Open in new tab ↗4D Print Path Planner
Design multi-material print schedules for shape-morphing SMP structures. Configure active and passive material zones, fiber orientation angles and stimulus sequences to predict shape change, curvature and actuation energy.
Open in new tab ↗Neural Interface Impedance Modeler
Models electrical impedance spectra and recording quality for softening SMP neural probes across acute and chronic implantation. Configure electrode geometry, substrate properties and tissue response to predict impedance at 1 kHz and SNR over time.
Open in new tab ↗Mach Thruster Lab
Explores the Woodward Mach Effect Thruster parameter space — capacitor stack geometry, drive frequency and predicted thrust against the experimental record. Retained as a research instrument from the propulsion investigation.
Open in new tab ↗